| View previous topic :: View next topic |
| Author |
Message |
bender1
Joined: 01 Dec 2006
Posts: 1
|
 Posted: Fri Dec 01, 2006 7:57 pm Post subject: Adding Inhibitor |
 |
|
I want to add some Sentinel X100 inhibitor to my system as I don't think it has inhibitor at present. I've been told to drain sufficient water out of the system to allow the inhibitor to be added to the header tank. I have 2 questions.
1. Will adding the inhibitor to the header tank cause the inhibitor to flow throughout the system? I thought the header tank was there just as a top up mechanism.
2. Why cant I scoop sufficient water out of the header tank to add the inhibitor instead of mucking about with a drain cock and hose? Doesn't this achieve the same thing?
Thanks for any help. |
|
| Back to top |
|
 |
krang_uk
Joined: 12 Dec 2005
Posts: 79
|
| Posted: Sat Dec 02, 2006 1:27 pm Post subject: |
|
|
| you need to drain some water out so it goes in to the system, not just sit in the tank. you should just drain a load out, till the water level in the tank is below the fill pipe.keep it going for a min or two. when you fill the system again, keep the ball vavle up and let it fill slowly so the inhibitor goes in to the sytem |
|
| Back to top |
|
|
|
